DISTRIBUTION TRANSFORMERS – HERMETICALLY SEALED CATALOGUE GUIDE

DISTRIBUTION TRANSFORMERS – HERMETICALLY SEALED CATALOGUE GUIDE
Hermetically sealed oil-immersed distribution transformers according to standards EN 60076 and EN 50464, up to 36 kV.

Characteristics

• Rated power from 100 up to 2’500 kVA, operating voltages up to 36 kV, 50 Hz
• Hermetically sealed execution without air cushion
• Tapping range on primary voltage: ± 2x2,5% or according to customer request
• Maximum ambient temperature 40°C, average annual temperature 20°C
• Maximum temperature rise of copper 65 K, top oil 60 K, natural air cooling ONAN
• Maximum installation altitude 1’000 m above sea level
• High voltage bushings: plug-in bushings according to DIN 47636 or porcelain bushings according to DIN 42531 for indoor- or
outdoor installation
• Low voltage bushings: porcelain bushings according to EN 50386 with or without flat connection plate
• Compact and leightweight
• 2 loss ranges: normal losses and low-loss design
• Routine tests according to EN 60076
• Low-radiation execution with 8 point symmetric low voltage bushings on request
• Integrated oil retention vat on request (mounted between tank and chassis frame)
• Increased winding insulation and earthed screen between HV/LV windings for non-sinusoidal load on request
• Integrated safety detector, pressure relief valve, filling level indication on request

CONTINUE READING THIS CATALOGUE GUIDE

Comments

PARTS OF A POWER TRANSFORMER

What are the name of the basic parts of a Power Transformer? We can not deny the fact that only a handful of electrical engineering students are presently familiar with power transformers especially on what it looks like. Unlike a transformer we found in our homes, a power transformer’s appearance and construction is somewhat more complicated. It is not just a simple winding with a primary and secondary terminal although basically any transformer has one. The function that a power transformer plays in an electrical system is very important that an electric utility can not afford to loss it during its operation. Our discussion here will focus more on the basic parts and functions of a power transformer that are usually tangible whenever you go to a substation . Although not all power transformers are identical, nonetheless they all have the following listed parts in which the way of construction may differ.

click here to continue

ELECTRIC MOTOR FRAME SIZE STANDARD SPECIFICATIONS

ELECTRIC MOTOR FRAME SIZE STANDARD SPECIFICATIONS How is electric motor frame size being specified? Motor frame dimensions have been standardized with a uniform frame size numbering system. This system was developed by NEMA and specific frame sizes have been assigned to standard motor ratings based on enclosure, horsepower and speed. The current standardized frames for integral horsepower induction motors ranges from 143T to 445T. These standards cover most motors in the range of one through two hundred horsepower. Typical example of where you can locate the frame is shown in Fig 1.2.D – Frame No. The numbers used to designate frame sizes have specific meanings based on the physical size of the motor. Some digits are related to the motor shaft height and the remaining digit or digits relate to the length of the motor. The rerate, or frame size reduction programs were brought about by advancements in motor technology relating mainly to higher temperature ratings of insulating mate...

click here to continue

ELECTRIC MOTOR NAMEPLATE SPECIFICATIONS

How do we interpret an electric motor nameplate? Motor standards are established on a country by country basis.Fortunately though, the standards can be grouped into two major categories: NEMA and IEC (and its derivatives). In North America, the National Electric Manufacturers Association (NEMA) sets motor standards, including what should go on the nameplate (NEMA Standard MG 1-10.40 "Nameplate Marking for Medium Single-Phase and Polyphase Induction Motors").

click here to continue

power systems loss

Search This Blog