Skip to main content

Philippine's Energy Regulatory Commission Lowers Systems Loss Cap

ERC Lowers System Loss Cap

 BY JORDEENE SHEEX LAGARE ON FEBRUARY 23, 2018
Manila Times

The Energy Regulatory Commission (ERC) has reduced system loss charges that distribution utilities (DUs) can pass on to their consumers.

In a statement on Wednesday, ERC said that under its Resolution 20, Series of 2017, DUs would have a 6.5-percent distribution loss this year. This would be gradually reduced annually until it reaches 5.5 percent by 2021.

Electric cooperatives (ECs), which will be grouped into three clusters based on technical considerations, shall impose a 12-percent cap for 2018.

They can charge between 8.25 percent and 12 percent until 2022 onward, depending on which cluster they are assigned to.

READ MORE
Labels:

Comments

Post a Comment

Popular posts from this blog

PARTS OF A POWER TRANSFORMER

What are the name of the basic parts of a Power Transformer? We can not deny the fact that only a handful of electrical engineering students are presently familiar with power transformers especially on what it looks like. Unlike a transformer we found in our homes, a power transformer’s appearance and construction is somewhat more complicated. It is not just a simple winding with a primary and secondary terminal although basically any transformer has one. The function that a power transformer plays in an electrical system is very important that an electric utility can not afford to loss it during its operation. Our discussion here will focus more on the basic parts and functions of a power transformer that are usually tangible whenever you go to a substation . Although not all power transformers are identical, nonetheless they all have the following listed parts in which the way of construction may differ.
50 comments
click here to continue

ELECTRIC MOTOR FRAME SIZE STANDARD SPECIFICATIONS

ELECTRIC MOTOR FRAME SIZE STANDARD SPECIFICATIONS How is electric motor frame size being specified? Motor frame dimensions have been standardized with a uniform frame size numbering system. This system was developed by NEMA and specific frame sizes have been assigned to standard motor ratings based on enclosure, horsepower and speed. The current standardized frames for integral horsepower induction motors ranges from 143T to 445T. These standards cover most motors in the range of one through two hundred horsepower. Typical example of where you can locate the frame is shown in Fig 1.2.D – Frame No. The numbers used to designate frame sizes have specific meanings based on the physical size of the motor. Some digits are related to the motor shaft height and the remaining digit or digits relate to the length of the motor. The rerate, or frame size reduction programs were brought about by advancements in motor technology relating mainly to higher temperature ratings of insulating mate...
5 comments
click here to continue

ELECTRIC MOTOR NAMEPLATE SPECIFICATIONS

How do we interpret an electric motor nameplate? Motor standards are established on a country by country basis.Fortunately though, the standards can be grouped into two major categories: NEMA and IEC (and its derivatives). In North America, the National Electric Manufacturers Association (NEMA) sets motor standards, including what should go on the nameplate (NEMA Standard MG 1-10.40 "Nameplate Marking for Medium Single-Phase and Polyphase Induction Motors").
44 comments
click here to continue